Cdi-torque MULTITEST Government User Manual download pdf (Page 36)

3-6

Setup and Programming

Setting Up High and Low Limits Alert

Torque/Force Mode

Use SET HIGH and SET LOW to protect the tool under test or

serve as a fastener installation torque or force preset alert. The

2000-610-02 produces a constant audible limits alert tone when

the input torque/force exceeds the SET LOW limit. It then

produces a pulsating limits alert tone when the input

torque/force exceeds the SET HIGH limit.

It is important to program these limits if statistical

analysis is to draw a histogram which includes

reporting out-of-limit parameters.

Changing transducers does not automatically change

SET HIGH and SET LOW limits.

Angle Mode

In the ANGLE mode, use SET LOW to program a clamping

torque limit and use SET HIGH to program an angle

measurement. For additional information refer to Torque-Angle

Measurement Modes in this chapter.

Setting Low Torque/Force Limit

1. Press SET LOW.

— The LED display reads:

last SET LOW value , with one digit flashing

— The LCD display reads:

Edit low limit - upper line

[units] - lower line

Change units of measure by pushing UNITS.

2. Select an LED digit to change (flashing) by pushing left

or right DIGIT.

3. Increment or decrement the selected digit by pushing up

or down VALUE. Push and hold up or down VALUE to

change the display quickly.

A decimal point "." appears between "9" and "0"

numerals. Maximum resolution is selected

automatically, regardless of decimal point position,

upon pushing ENTER. The program value is

absolute, for both ± readings.

4. Select and change the next LED digit using left and right

DIGIT and up and down VALUE. Continue until all digits

are set.

5. Press ENTER to return to measurements mode.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 95 96

No comments

Cdi-torque MULTITEST Government User Manual Page 36