Cdi-torque MULTITEST Government User Manual download pdf (Page 40)

3-10

Setup and Programming

4. Press ENTER to clear the last memory location. The

number of total memory locations decrements by one.

Pushing ENTER repeatedly continues to clear readings

from the top of the list down.

5. Press left DIGIT to select "None".

6. Press ENTER to return to RECALL mode.

7. Press ENTER again to return to measurements mode.

Clear Single Memory Location

Use the procedure in this section to clear a single memory

location.

1. Press RECALL DATA.

— The LCD display reads as shown in Figure 3-5. The

present memory location at the upper left, total

number of memory locations to the right and time

data was stored at far right.

— The LED display shows the measurement value of

that memory location while the LCD displays its

engineering units at the lower right.

2. Press up or down VALUE to select the particular memory

location to clear.

3. Press MANUAL CLEAR. The LCD display shows

"CLEAR" and the present (left) and total (right) memory

locations on the upper line, as shown in Figure 3-6.

4. Press right DIGIT to select "Single" on the lower LCD

line.

5. Press ENTER to clear the present memory location. The

number of total memory locations decrements by one

and all subsequent measurements move down one

location.

Push ENTER repeatedly to continually clear

readings until all subsequent and then prior

locations clear.

6. Press left DIGIT to select "None".

7. Press ENTER to return to RECALL mode.

8. Press ENTER again to return to measurements mode.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 95 96

No comments

Cdi-torque MULTITEST Government User Manual Page 40