Cdi-torque MULTITEST Government User Manual download pdf (Page 46)

3-16

Setup and Programming

3. Using up and down VALUE and left and right DIGIT,

enter the clamping torque from the fastener torque-angle

specification onto the LED display.

4. Press ENTER.

5. Press SET HIGH.

— LED display shows the previously programmed

degrees of rotation preset value.

— LCD display reads:

Edit max. angle

Figure 3-9: Edit Angle Display

6. Using up and down VALUE and left and right DIGIT,

enter the degrees of rotation from the fastener torque-

angle specification onto the LED display.

7. Press ENTER to return to measurements mode.

Setting Angle Only Measurements

Certain fastener procedures involve multiple nuts or bolts to be

installed in a particular pattern. Using torque-angle

engineering, all fasteners are sequentially installed to a

specified clamping torque (sometimes two separate torques)

and then sequentially rotated a specified number of angular

degrees.

To measure angle only, use the following procedure to set SET

LOW to zero in the ANGLE mode.

1. Select ANGLE mode using MODE.

2. Press SET LOW.

— The LED displays the previously programmed

clamping torque preset value.

— The LCD display reads:

Clamping torque - upper line

[units] - lower line

3. Using up and down VALUE and left and right DIGIT,

enter zero onto the LED display.

4. Press ENTER.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 95 96

No comments

Cdi-torque MULTITEST Government User Manual Page 46