Cdi-torque MULTITEST Government User Manual download pdf (Page 13)

III

Safety Information

WARNING

• Make sure all components, including, adaptors,

extensions, drivers and sockets are rated to

match or exceed the torque or load being applied.

• Be sure the capacity of the MULTITEST system

matches or exceeds each application before

performing a procedure.

• Do not use the MULTITEST system if it makes

unusual noises, has loose parts, or shows any

other sign of damage. Have repairs performed at

an Authorized Service Center before use.

• Do not use chipped, cracked, or damaged sockets

and accessories.

• Do not remove any labels. Replace any damaged

label.

• Follow good, professional tool practices:

— Pull on a wrench handle—do not push—and

adjust stance to prevent a possible fall.

— Do not use extensions, such as a pipe, on a

wrench handle.

• When using ratchets, make sure the direction

lever is fully engaged in the correct position.

• Never attempt to test an impact tool on this

instrument.

• Always position the 40" arm over the front of the

stand as shown. Never extend the test arm

behind the stand. The stand will tip over when

weights are applied.

• Always be alert to the potential for personal injury

that may be caused by excessive torque

applications, careless handling of heavy weights,

and out-of-balance or unsafe weight distribution.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 95 96

No comments

Cdi-torque MULTITEST Government User Manual Page 13